HD Issues

hi!!!
i used the following debug routine to reset my bios and hard disk. Now the problem is that i am unable to partition my hard disk using fdisk or DM. All changes are done but when i try to apply the changes it says (disk write error).

A:\>debug <enter>
-fcs:200 400 0 <enter>
-acs:100 <enter>
-xxxx:0100 mov ax, 0 <enter>
-xxxx:0103 mov ax, cx <enter>
-xxxx:0105 out 70, al <enter>
-xxxx:0107 mov ax, 0 <enter>
-xxxx:010a out 71,al <enter>
-xxxx:010c inc cx <enter>
-xxxx:010d cmp cx,100 <enter>
-xxxx:0111 jb 103 <enter>
-xxxx:0113 mov ax,302 <enter>
-xxxx:0116 mov bx,200 <enter>
-xxxx:0119 mov cx,1 <enter>
-xxxx:011c mov dx,80 <enter>
-xxxx:011f int 13 <enter>
-xxxx:012l int 20 <enter>
-xxxx:0123 <enter> (without typing anything.)
-g <enter>
program terminated normally

I am usin a SHARP Laptop 150 MHz and my hard disk model is Fujitsu (M2724TA)(1.5 GB).
Any help would be highly appretiated.

I found your script right here in the Computer Hope Help pages. You may have damaged your disk.

http://www.computerhope.com/rdebug.htm

Disclaimer:

The following are various Debug Routines that you can run on your computer to do various tasks. However, some can possibly damage computer components or cause them not to work properly. We are providing these debug routines as a reference. If these cause problems with the computer they are ran on Computer Hope will not be held responsible for your actions. We recommend that only experienced computer users being aware of the potential hazards use the following routines.

I would suggest taking the PC to a computer shop for a full analysis.

Good luck.