Hi I am working in an environment with wds/mdt 2012 setup for deploying images( I was using clonezilla before as imaging software). I want to sysprep and capture the image of a reference computer imaged by clonezilla then upload it to mdt to deploy later. There is only one problem, sysprep always fail when I run it. I can capture the image without running sysprep, redeploy it and it run just fine. I checked in the registry and the image state say complete which indicate that the image has been sysprep before, even though I did not run sysprep on the image. Can i keep using the capture image without running sysprep or do I need to run sysprep again