Ghost 2003 Cloned Partition not booting

[philb101]

I had a 150G HDD C: & bought a 450G HDD, I partitioned the 450G to 150G & 300G, D: & E: respectively
Using Ghost 2003 I Cloned partition C: to D:
No problem until I removed Drive C: & Installed D: as the boot device
"Disk Boot Failure, Insert system disk & Press Enter"

If I connect D: as a Slave all the data as C: is there

how can I get it to boot ?

Thanks for all helpost 2003 Cloned Partition not booting

[Spero-T]

Check the hard drive documentation or the label on the drive itself for master/slave jumper settings.

[kuszmania9999]

i got this one before,check which one is master / slave and jumper as well...don't ever forget the IDE bus / SATA bus,you probably connect incorrectly to the master or slave HDD. 

[patio]

Guys he stated he removed the C: drive...
Phil when you set the partitions on the new drive did you remember to make the first partition active ? ?
What partition utility did you use ? ?

[kuszmania9999]

uppsss....my bad..