Computer Hope

Hardware => Hardware => Topic started by: micmerzo on August 09, 2010, 12:15:07 PM

Title: wiring new power supply
Post by: micmerzo on August 09, 2010, 12:15:07 PM

I replaced my atx power supply but I don't have it wired right.  When I plug everything in I get a red error message about a master and slave.  I unplugged the two cd drives and the computer works fine, but no cd players. Where can I find a diagram to show what order I should plug the connectors in.  Some of these long wires have multiple plugs.  It is a Nupower (redimax) rx 380k

Title: Re: wiring new power supply
Post by: Computer_Commando on August 09, 2010, 12:41:59 PM

How to Replace an ATX Power Supply (PSU) (http://www.fonerbooks.com/r_power.htm)

Title: Re: wiring new power supply
Post by: hejlik on August 09, 2010, 12:44:32 PM

It sounds like the ribbon cable was installed wrong. Did you take it off the drives when you put the new power supply in?