Computer Hope

Software => Computer software => Topic started by: laxmi_bsnl on January 18, 2012, 06:44:14 AM

Title: foxpro
Post by: laxmi_bsnl on January 18, 2012, 06:44:14 AM

hello to every body

I am using windows xp and while accessing foxpro from command prompt the following message is displaying.

Phar Lasp err35: The 386 chip is currentlyexecuting in virtual 8086 mode under the control of another programme.  You must turn off this other programme in order to use 386: Dos-Extension to run in protected mode.

how to overcome this problem and how to access foxpro?

i am very happy if anybody solve my problem.

Title: Re: foxpro
Post by: truenorth on January 18, 2012, 08:44:18 AM

Others have found solutions here: http://forums.autodesk.com/t5/AutoCAD-R12-R13-R14-Archive/phar-lap-error-35-grr/td-p/927
Hope you will also,truenorth

Title: Re: foxpro
Post by: BC_Programmer on January 18, 2012, 09:29:42 AM

What version of foxpro?

Why can't you upgrade to a later version that doesn't rely on DOS?

The error message indicates that it can't run in Virtual 8086 Mode. that means you can't run it under windows at all.

You might try something like DosBox.

Title: Re: foxpro
Post by: laxmi_bsnl on January 20, 2012, 05:13:47 AM

2.6 a version