Computer Hope
Hardware => Hardware => Topic started by: totalnoob on January 14, 2014, 07:04:45 AM
-
I have reacently cleaned dust in my pc. I took ram out and gpu, i have cleaned everything. When i tryed to turn it on again afer cleaning my pc didnt boot it just beeps every few sec i open pc and saw that gpu fan is spinning very slow or eaven doesnt spin. What did i do? Did i break my gpu or something. Can i fix it somehow? Pls help guys!
-
What method did you use for cleaning it out ? ?
1st thing i would check is all connections to the MBoard...
-
I blow the dust, didnt use water. Everything is connected.
-
You may have blown off a MBoard jumper then...check the Owner's Manual for locations.
BTW did you remove the CPU fan as well ? ?
-
Didnt touch cpu fan.
-
OK...See Above...
NOTE: The header wires...which go to fans and the front connecters are also flimsy enough to be blown off their pins...
-
I think its not about jumpers or connection. My motherboard dont have jumpers . Is it possible that i have problems with psu? It feels like my gpu is not getting enough power or something. Can i somehow check if my gpu isnt broken?
-
2 things you can do to test::
A) Try it with the vid card removed using onboard grafix...
B)Borrow a known good PSU of the same or greater wattage and swap it in there overnite to test...
-
Did you try reseat RAM?? As far as the beeping is concerned, i would first to reseat RAM.
-
Hey tnx man i got boot but still gpu fan doesnt work. Any sugsestions for that?
-
Did you check if the fan has any wire that needs to be connected to run the fan? Check if it is not unplugged.
-
Its all connected, i think the fan is dead.
-
Then you need to replace the card.
-
Check for solid dust particles stuck in fan. What happens when you move it with finger??
-
Check for solid dust particles stuck in fan. What happens when you move it with finger??
Zebras.
Replace the display adapter.
-
If i move it with finger it spins slow for 2 sec and then stops. There is no dust like i said have cleaned it.
-
Zebras.
Replace the display adapter.
EDIT: Sorry, just read your post. Yeah, I too think the adapter should be replaced. I was just curious if the fan is supposed to spin all the time...