Computer Hope
Hardware => Hardware => Topic started by: guyb on February 12, 2006, 05:22:32 PM
-
I installed a 2nd hard drive (Seagate 250), and another memory card (Ultra 512) to my KMA AM39L-L board. Now when I turn the power everything powers up but....
#1 There is no "beep" as it is powering up
#2 The monitor which has been plugged in and out a number of times keeps giving me the self test
Needless to say I am STUCK!!!! Any suggestions??
-
Rule #1 - Only introduce one variable at a time. Take out the second RAM for now and replace firmly in slot. If it doesn't work take iti out for now. We'll deal with it later.
Is the new hard drive jumpered as slave and the original as master? If the machine now boots, is it seen in the BIOS?
Keep us posted.
-
Thank you.
Took memory out.
turned power on... nothing..... :-?
-
So if you leave just the old RAM in there and the hard drive not attached it works?
If so, tell us what happened with the hard drive jumpering.
-
No, just hooking up the original HD it wont work. We tried all the jumper possibilities of the master/slave and the channel select or select. But when you turn it on we dont even get a beep. We have unplugged and replugged everything!! :'(
-
So you have JUST the original RAM and the original hard drive, jumpered as master, and nothing happens? If so, remove and reseat the RAM and try again. Now what?
-
Tried that and nothing.