Computer Hope
Hardware => Hardware => Topic started by: Quickster on September 25, 2006, 11:44:01 PM
-
I just got a new Hard-drive to install into my computer. This is the first time I've ever had this kind of problem. My motherboard runs the CD-drive and the Harddrive fine by them selves. But as soon as I plug in either with an IDE cable or power cable niether of hte devices work properly.
-
The jumpers are most likely not set to Master/Slave.
Make the HDD Master and the CD-ROM Slave. Instructions are printed on top of the HDD and CD-ROM.
-
Or run them both as Master on separate IDE channels for best results. ;)
-
Doubt you'd notice an performance hit. I know I didn't.