Computer Hope
Microsoft => Microsoft Windows => Windows XP => Topic started by: carmen on September 14, 2007, 08:42:33 AM
-
I need your help. i try to install a new hdd, but i had to take it out because the computer did not reconized it. when i try putting the old hdd back to the pc it giving me problems. i turn on the computer i get a message- hardware monitor found error enter power setup for ditail. f1-f2. but if i hit f1 it will boots and take me to windows. the computer is working fine but it take me to the cmos setup everytime i load my pc. the os is windows xp
can someone help me
thanks
-
If it is taking you to setup each time you boot then either you made a change in the BIOS while in there that it does not like or there is a hardware issue...
Are both drives still connected ? ?
If so or not have you checked the jumpers and cable positions ? ?
One hard drive = Set as master and hooked to the end of the IDE cable...
2 HDD's = One set as master cabled as above with the second set as slave and connected to the middle IDE connector...
Note: Some drives have a master/w slave present jumper setting which should be used if there is more than one hard drive connected.
Note #2: Most drives will have a diagram on there label as to how to set the jumpers.
Let us Know.