Computer Hope

Hardware => Hardware => Topic started by: sree on August 22, 2008, 05:45:58 AM

Title: Reg: problem at boot time
Post by: sree on August 22, 2008, 05:45:58 AM

Hello All,

      I recently Upgraded my RAM to 2GB, at the time of booting it showing this message " IC fail. Please enter setup to change OC fail settings" and it keep on showing that only..... until i press F1 to continue ....

     Can any one please tell me why it was showing... is there any chip failure... Mine is HP dx2280MT system...

Title: Re: Reg: problem at boot time
Post by: Annon on August 22, 2008, 08:23:00 AM

OC means over clocking; one component of your pc is set to a higher frequency.

You can load the fail safe in bios and set other options manually.

I would advise you to check the frequency and voltages first, It is found in bios itself.

 ;D