Computer Hope
Hardware => Hardware => Topic started by: copas on February 23, 2009, 09:13:38 PM
-
My computer is a desktop running Vista Ultimate with an Intel motherboard.
It was doing fine for nearly a year with powered stereo speakers. I thought the speaker set went bad for when there was no sound I unplugged them and they had a loud 60 HZ hum. I set them aside and plugged in another set of speakers I had that were unpowered. No sound, and I took this to be caused by the unpowered speakers. I then plugged in a PCI sound card and plugged the unpowered speakers into this expecting great things. They do work but at a miserable low level. With the volume all the way up. I have good drivers with the sound card and device manager says all ok.
I don't understand this system too well. Does anyone have any ideas?
What voltage and waveform are normal on the stereo output jacks?
Thanks for any suggestions.
-
When You unplug your powered speakers & har a hum it is normal. This is noise from an ungrounded line. If you put your finger on the very end it will get louder. If you put your finger on the all 3 metal strips or just the 1 closest to the plastic of the plug, noise will cease. As for a normal soundwave it would look ragged & peaked as opposed to a standard sine-wave. It's level could be any where from 1 0r 2 mV[millivolts] up to 1 or 2 Volt depending on the board...
For this you may want to go to Control Panel > Sound , Dbl Click & make sure your deviceis enabled and there is a meter with a bar jumping up and down like the music would make it do.
If you have a Control Panel or Audio Mgr for the onboard sound or the sound board itself, open it and go thru to make sure nothing is amiss there.
Also be sure to check the obvious, ex.: headphones not plugged so that sound to speakers is cut off.....