Computer Hope
Hardware => Drivers => Topic started by: Tundrawalker on June 25, 2009, 02:07:53 PM
-
I would like to know how to determine which physical ports on a PC are USB 2.0, or enhanced, and which ports are standard USB ports.
I'm running Windows XP SP3, when I use my Epsom R300 printer, I sometimes see a message bubble that says, in effect, my printer would print faster if it were plugged into a USB 2.0 port.
-
Do you have it plugged into a USP hub or port replicator?
-
Hi
mmm.. try checking this http://support.apple.com/kb/HT1174 (http://support.apple.com/kb/HT1174). Probably it could help.
-
Check your motherboard manual for specifications of your USB ports.
-
mmm.. try checking this http://support.apple.com/kb/HT1174. Probably it could help.
Why would you send him to Apple?
physical ports on a PC
-
Why would you send him to Apple?
:-* No. I just want him to see that content of the page. Not necessarily to send him to apple.
-
Fair enough.
I must admit that I was quite surprised to see MS support on an Apple site though. That must really grab Steve Jobs by short and curlies.
-
Perhaps I wasn't clear. I have two ports on the front of my tower type computer. There are two ports on the front and four ports on the back, presumably attached directly to the motherboard.
I don't have the motherboard manual, as Karnac suggested (thank you, by the way). I looked at the apple website and I didn't see any thing new to me. Looking at the Device Manager doesn't tell me what port to plug into. I'm looking for a simple method to identify the physical port. Do I plug in, say a jump drive, then look at the Device Manager for a connection? Is there a freeware/shareware/purchased software program that would identify the types of ports? I have asked my company's geeks this question and no one I know can find an answer.
Thanks for the help and replies.
Tundrawalker
-
If you plug a thumbdrive in- windows will complain if you plug it into a 1.1 port. It won't say anything if you plug it in a 2.0 port, however.
-
Try Everest
You'll also be able to get a motherboard model.
http://majorgeeks.com/download4181.html
-
If you see the message that the device can run faster then that is a 1.1. port.
-
Bet my bottom dollar the rear are 2.0 and the front are 1.1....... ::)
-
I sometimes see a message bubble that says, in effect, my printer would print faster if it were plugged into a USB 2.0 port.
Usually if you see this message, you've plugged the device into a USB 1.1 port. Or, in some cases, this means your motherboard chipset drivers are not installed.