Installed new DVD Burner / Now CD Burner won't work

[Evenflow]

Okay, I went into the Bios. I hope this is the correct info. that your telling me to check.  On my drive configuration it had............

Diskette Drive A:   3.5 Inch, 144 MB
Primary Master Drive............Hard Drive
Primary Slave Drive..............Off
Secondary Master Drive.........CD-ROM Device
Secondary Slave Drive...........Unknown Device

IDE Drive UDMA..........ON

Also, Showing when I go into My computer I also have listed a drive ( F: ) Which says Removable Disk, which I didn't have before I put the new DVD drive in.

[OpenSource]

Unknown device eh?  Well at least something is showing up.  What kind of DVD burner do you have?

[Evenflow]

 A cheapee Samsung SH-S222L 22X LS. I ordered it from Newegg. So far it works fine and it shows up on the ( D: ) drive.

[patio]

Have you checked the jumpers on each drive and cabled them as suggested ? ?

Not a perfect image here but it may help:

           

NOTE: All drives are different....look for diagrams on the plastic case above the jumper position...

[Evenflow]

Like I said before.....I'm not a whiz....don't make fun of me but, you are talking about my hard drive to check this....right ? 

[patio]

No...both Optical drives...

Thats why i mentioned it wasn't the perfect image...but would help.

And we don't make fun...our job is to help educate.

[Evenflow]

Okay, I'll have to unhook everything again and check this out. Thank you for all your help.

[Computer_Commando]

CD-ROMS are labeled MS, SL, CS, punched  into the metal case above the jumper block.  Not always easy to see, but it's there.

[JJ 3000]

Here's a pic of a CD drive jumpered as slave. It should help you figure this out.