Welcome guest. Before posting on our computer help forum, you must register. Click here it's easy and free.

« previous next »
Pages: [1]   Go Down

Author Topic: Reg: problem at boot time  (Read 2041 times)

0 Members and 1 Guest are viewing this topic.

sree

    Topic Starter


    Beginner

    Reg: problem at boot time
    « on: August 22, 2008, 05:45:58 AM »
    Hello All,

          I recently Upgraded my RAM to 2GB, at the time of booting it showing this message " IC fail. Please enter setup to change OC fail settings" and it keep on showing that only..... until i press F1 to continue ....

         Can any one please tell me why it was showing... is there any chip failure... Mine is HP dx2280MT system...
    Logged

    Annon

    • Guest
    Re: Reg: problem at boot time
    « Reply #1 on: August 22, 2008, 08:23:00 AM »
    OC means over clocking; one component of your pc is set to a higher frequency.

    You can load the fail safe in bios and set other options manually.

    I would advise you to check the frequency and voltages first, It is found in bios itself.

     ;D
    Logged
    Pages: [1]   Go Up
    « previous next »