under system devices:
ATI SMBUS No drivers are installed for this device. But under resources tab shows conflicting device list, Input/Output Range 8040 - 804F used by: Motherboard resources
Direct memory access controller: No drivers are installed for this device.
listed Twice - (1) Motherboard resource: No drivers are installed for this device.
(2) Motherboard resource: No drivers are installed for this device. But under resources tab shows conflicting device list, Input/Output Range 8000 - 805F used by: ATI SMBUS
Numeric data processor: No drivers are installed for this device.
Programmable interrupt controller: No drivers are installed for this device.
System board: No drivers are installed for this device.
System speaker: No drivers are installed for this device.
System timer: No drivers are installed for this device.
Would like to note on all above entries, on General taps, Device usage, it's listed as use this device (enable). On Resource taps there all listed as setting based upon (current configuration) which is greyed out. Could this be the problem?
Would be willing to send Everest report if asked.