I get Add a new hard disk, install existing hard disk, maintenance options(-->create an ontrack boot diskette, update mbr boot code, backup or restore mbr), utilities(-->copy a partition, set hard drive size, zero fill drive(full),zero fill drive(quick)), Hard Disk Information(-->display technical hard drive information, view hard drive jumper settings)
I chose hard disk information and then selected my drive. I was given the following:
IDE Information
Size
LBA Sectors 312581808(160.04 GB) CHS 16383 X 16 X 63 (8.46GB)
DMA
MW DMA SUPPORT 0,1,2 MW DMA Active
MW DMA CYCLE TIME 120 ns Min. Cycle/Word 120 ns
UltraDMA Support 0,1,2,3,4,5,6 UltraDMA ACtive 5
Misc.
Firmware Rev. TM100-2
S.M.A.R.T. Support Enabled
ATA-# Supported 7,6,5,4,3,2 IORDY Support YES
R/W Multiple YES Sectors/Block 16
PIO Mode Support 3,4 PIO Cycle Time 120ns
Translation Information
MBR Partition Table
Type Bootable Begin CHS End CHS Size
B true 0 1 1 842 239 63 6.53 GB
7 false 843 0 1 20671 239 63 153.51 GB
0 false 0 0 0 0 0 0 0
0 false 0 0 0 0 0 0 0
Translation
CHS Values BIOS XBIOS Logical XBIOS Physical
Cylinders 20673 19457 16383
Heads 240 255 16
Sectors/Track 63 63 63
Everything look okay? Also, I noticed that when I changed the boot order there was not anything in position 1, hard disk was in position 2, cd rom was in position 3, and nothing was in position 4. Is it normal for the first slot to not be used? I appreciate any help you can give me on the next steps to take. Thanks