Computer doesn't recognize new hard disk

[Rixter]

In an earlier post; Dell refuses to start after battery replacement. I removed one of the dell's hard disks and put it in my siemens/hitachi.starts up fine but doesn't show that there's another hard disk. Should i remove/move those whiter plastic 'bridges' to different pins to make it slave /master?

[patio]

It should be jumpered as slave if it is a secondary drive...

Cabling:

MB===================================Master=========Slave.

Also...double check your primary drive...some need to be jumpered master/w slave when a 2nd drive is added...

PS. You shouldn't try to boot to the 2nd drive since it came from another machine if you have a version of Windows newer than WinME.

[Rixter]

Thank you for your time patio..the problem is that there are /is label on back of hard disk with symbols that i know not much about. It's international i guess but i am in sweden.So you write that it should look like you wrote: MB  master...slave Is that where I put the little white plugs? please forgive my ignorance.I appreciate very much your help

[patio]

No...that is how the cable is setup inside the machine...
motherboard============================master drive======then slave drive...


Here is a picture of a common jumper setting:




Keep in mind all drives are not setup the same way...
Check the manuf. site for more info for each drive.

[patio]

This is a wide grey ribbon cable connecting the drives ...correct ? ?

[Rixter]

Yes, Patio..Thank you very, very much for all the time that you took to help me. All is fine now. You are best!

[patio]

Stop by anytime...