Floppy Drive error

[oscarandmatty]

I have installed a new Hard drive and when i turned on the computer, while in DOS it tells me: "Drive A error". I checked cables and power, everythign looks good. The LED light turns on when i put a diskette in it. The problem that i have is that I need a floppy in order to start the computer and install the OS in my hard drive. Can anyone give me an idea of what can be the problem?.

[merlin]

http://www.computerhope.com/issues/ch000230.htm

http://www.computerhope.com/issues/ch000381.htm

and what o/s..you can change the boot sequence in the bios?to boot from cdrom and format the hard drive ..

[Oscar Adrianzen]

The hard drive has been formatted already. After the format was completed, the system does not read A or D drive at all. I need the A drive in order to use the boot up disk. I already checked the boot sequence inthe BIOS and is set to start with the Floppy drive, but still does not work.

[MalikTous]

If the HDD LED and/or FDD LED are on continuously, you may have the FDD cable on backwards or shifted over a pin or two.

Check your jumper settings. If a HD is set to, for example, Single vice Master when you have a slave drive, or if a drive is set to Cable Select when it should be on Master or Single, that can bollix the IDs.

Try setting the BIOS to 'Default'.