I have a question regarding the jumper settings. I had to remove the jumper to get it to stop a reboot cycle, so now there is no jumper on it. I tried it as cable select, slave and master befor just pulling it off all together, same thing I had to do to the old hd.It is pluued into the end plug on the cable.
When looking in BIOS its saying Primary IDE Master is not detected, Primary IDE Slave Hard Disk. Secondary IDE Master not detected, Secondary IDE Slave CD/DVD ROM
Is this correct? If not what should it be and how can I fix it?
I'm tired of fooling with it for now and I'm going to bed but will start up again in the morning. I'm trying to pull up the pcchips website to find my mb information but its taking forever (I hate only having dialup!)
I dont have any cds for the seagate, it came pre installed with the external box and I didnt get anything with it.
Catch up in the AM, Thanks!