1394 bus controller not detected

[marooned]

Hi all
hope somebody can help me with this problem.

Op sys ; Win Me
Iomega USB External CD-RW drive.

CD-RW not listed in Device manager under CDRom.( The drive is not detected)

USB mass storage device has yellow exclamation.
USBSTOR.INF and USBSTOR.sys in system32.

1394 Bus controller or Host controller not listed either in Device Manager or IRQ Resource List.

i added a IRQ10 which was free. How can make 1394 controller listed.

many thanks for any help. Can anyone please e-mail me?

Marooned

[Flame]

I did not find anything for Windows ME, but this might work for you... Give it a shot... http://support.microsoft.com/default.aspx?scid=kb;en-us;221823 ... Also, if you become a member here, you can get E-Mail notification of replys... Having us E-mail you is too hard, and you will of course have a nuimber of us helping you... Your solutions may be repeated...

[glb]Flame[/glb]

[merlin_2]

Is  plug and play enabled in the bios......how may usb devices have you got.....and how many usb ports...software first......hardware next.....info>http://support.microsoft.com/default.aspx?scid=kb;en-us;q221823

[marooned]

 
Hi Flaming and Merlin_2
Thanks a million for immediate response.
I will try the URL.
This is a Dell lap top with only one USB port. I can only use one USB device at a time.

canon USB Printer, IOmega CD-RW drive, occassionally 2megaPix Dig camera

Thanks & regards
Marooned

[marooned]

Hi Flaming and Merlin_2

I have solved the problem of my CD-RW (USB).
after long hours of trial and errors realised the following:

Do not unmount the USB device before  stopping the device.

Op systems from 98SE onwards have drivers for almost all the Cd, CD-RWs. Let the windows load the drivers. Do not use the Iomega zip drive installation disk especially if you are going to load later versions of
ECCD. There are conflict between the older drivers and newer drivers.
This corrupts the drivers.

So the first thing I learned is not to use the manufacturers installation Disc. There are registry hacks etc I learned during this process which are sometimes risky. So the easiest way now.

Copy the important files. I used a lapLink and transferred my files to desk top.

Reformatted disk, reloaded WinME and allowed the system to load drivers for USB CDRW.

Installed later version of ECCD burning software and everyting is OK now.

This took me much less time and Internet cost.

There may be better ways but I have got back my CDRW functional again this way.

Thanks for your help and time

Regards, Marooned

This is an excellent Forum and I will continue to use it