Windows Start but only showing cursor

[chr1sde4d]

I done repair install, but after 100% copying files there is an error, I restart the computer then it say:
Windows could not start because of an error in the software
Please report this problem as:
load needed DLLs for kernel.

[Allan]

Did you do the repair install with the same version of Windows (home / pro) and service pack as was already installed?

[chr1sde4d]

yes is the same cd that install windows xp in my computer

[Allan]

That error is generated when the Hal.dll and Ntoskrnl.exe files are mismatched, but a repair install is supposed to fix the problem (unless the installed version differs from the repair install version).The only thing I can suggest is redoing the repair install. Sorry.

[chr1sde4d]

I did the repair install again, but still the same, after 100%, it show blue screen and it say a problem been detected. And after reboot still the same problem.
I don't know what else to do.

[Allan]

Can you tell me what the blue screen error message is?

[chr1sde4d]

It say:
A problem has been detected and windows has been shut down to prevent damage to your computer

PAGE_FAULT_IN_NONPAGED_AREA

If this the first time you've seen this stop error screen, restart your computer. If this screen appears again, follow these steps:

Check to make sure any new hardware or software is properly installed. If this is a new installation, ask your software manufacturer for any updates you might need.

If problems continue, disable or remove any newly installed hardware or software. Disable BIOS memory options such as caching or shadowing. If you need to use safe mode to remove or disable components, restart your computer, press F8 to select Advanced Startup options, and then select safe mode.

Technical Information:

*** stop: 0x00000050 (0xD00C0000, 0x00000000, 0x809121DF, 0x00000000)

[Quantos]

Here's what MS says about that particular stop code.  With a fix.

[chr1sde4d]

I tried to do the fix, but thing is I can't even go to safe mode, I press F8 when my computer start up, and a menu shows up to choose boot device, then I press ESC, but after that the same message as before came up:

load needed DLLs for kernel

I can't go into Windows

[Allan]

Well, the only things left are to download a memory diagnostic utility on another computer and then run it on this one and then do a format and reinstall of the OS if the ram passes the test. I'm sorry, but I don't know what else to suggest. The repair install should have fixed your problem.

[patio]

I would also delete/merge some partitions...12G is not alot of breathing room for an XP install as time goes on.

I'd go a minimum of 20 at least...

[chr1sde4d]

Will I lost my data?
If yes, is there a way to save it?

[Allan]

Yes, you will lose your data. You can try slaving the drive on a different computer to see if you can access your data from there. I'm really sorry - I was certain we'd be able to get you back in with the Repair Install.

[chr1sde4d]

is there any other way to save my data?
I can't connect my drive to the computer i'm using now, bcoz it use different cable, the mboard is old, so it have different connection cable.

[chr1sde4d]

can I just install new windows xp to my computer and then uninstall the broken windows xp?
If can, how to uninstall the broken windows xp?