When I opened the casing of my pc I accidentally unplugged the sata cable in my hard disk..When I plugged it again I encounter these messages at start up:
Auto-detecting pri master…not detected
Auto-detecting pri slave…not detected
Auto-detecting sec master…not detected
Auto-detecting sec slave…not detected
CMOS Setting Wrong / CMOS GPNV checksum BAd..
I change the sata cable thinking there might be a problem with the cable but still I encounter same messages…
Auto-detecting pri master…not detected
Auto-detecting pri slave…not detected
Auto-detecting sec master…not detected
Auto-detecting sec slave…not detected
CMOS Setting Wrong/CMOS GPNV checksum BAd..
When I checked IDE devices at SET up it says;
Primary IDE Master…not installed
Primary IDE Slave..not installed
Secondary IDE Master ..not installed
Secondary IDE Slave..not installed
What could possibly the problem with my pc
Hope this info could help:
OS: XP
Mobo: Asrock Prescott 533
Hard drive: Seagate
RAM: DDR 266 – 512MB 8 mb shared memory
Processor Type: Celeron R CPU