I run W98 on a 4 year old Compaq desktop (my own). Celeron 466Mhz chip, 64Meg Memory, 7.857 Gig disk.
Re-installed all the software from the Compaq restore disk.
One day I started and was informed to start in Safe Mode - can't rember upsetting the PC on closing before.
Started in Safe Mode and then closed down - started again in Normal Mode BUT on clicking any of the desktop icons they "blink" as if to say they are about go to the program I need but never get there - no other error messages.
By holding F8 at boot-up and selecting Safe Mode the PC is fine and I can open all the programs - run defrag and scandisk etc.
Any suggestions as I don't want to format the C drive and lose some very valuable data in files which are too large to go onto a 3.5" floppy.
Any ideas for restoring health would be most welcome.
Regards,
TioBasilio.