Took out RAM - now BEEP

[Bilko]

Hi Everyone,

I took out the ram from my Dell Dimension just to see what kind it was and to see if a new kind of RAM I pilfered from another
old Del would work in it.

I put it back where I found it (at least I think) now the computer won't start - it just beeps...

Is she dead? What can I do?

Any help GREATLY appreciated.

- Bilko

[Allan]

I assume you are now just using the original ram configuration and are not using the new ram. If that's correct, just open the case and reseat the ram. You should always discharge any static electricity from your body by touching metal before touching ram.

[Bilko]

Thanks for your reply Allan.

I have reseated (the old) RAM.

Is it possible that it's in incorrectly?

I've tried it both ways and I seem to have the problem either way...

[Allan]

If there are only two slots and both sticks are the same size, then it doesn't matter. Try booting with one stick at a time. It's possible you damaged one of them.

[Computer_Commando]

...I've tried it both ways and I seem to have the problem either way...

Doing that will damage the slots.  They only insert one way.  That's what the notch is for.

[Allan]

I'm sure he meant he switched the location of the two sticks.

[Bilko]

Thanks to you both - cause I was trying them in all directions...

I'll give booting with one at a time a try tomorrow and let you know how it goes.

Thanks again!

[Computer_Commando]

http://www.pcguide.com/byop/byop_InsertingtheRAMChips.htm

[Bilko]

Thanks for your help everyone. I was able to reinstall the RAM successfully.

Does anyone know where I can purchase old RAM for older desktops?