I have installed a 40 gig in a beater without removing the orig. 9.5 gig and would like to know how to use them in unisyn?I have ME on the 9.5 and would like to slave the 40?Is this a simple (N) i don't want to enable large disk support at the install?It boots fine when the end of the ribbon is plugged to original but not when the middle is?Is there a switch or boot order? If so where?I knew how on my thinkpad but dont on my pc?the placement of the drives within the tower makes it hard to run the ribbon differently?If u have an answer ? please help thanks?!
