I got a new board(Gigabyte GA-MA78GM-S2H) and I cannot get into the BIOS setup. In fact, on POST it will not detect the correct amount or speed of the RAM and I've tried two different types. It gets the same result both times. It'll find the SATA HDD and SATA DVD drive, but no amount of key pressing will get me to the BIOS setup. I always get to a blank screen with a blinking cursor. It'll say it's going to the setup, but then the blinking cursor is all I get. If I reset the CMOS I can get to a screen where it'll tell me there's a checksum error and it gives me the normal options: load defaults, last known good, etc....still same result no matter what...the blinking cursor. What is the problem here? I've swapped this board out once after my last one died after a whole two days and now this. I'm almost ready to give up.