Scanning photo’s to “my pictures” file

[ned1]

   In the past I have been scanning photos without a problem, But this time I cannot get a good print form  my pictures folder after I `ve scanned them in, it saves in jpeg into the folder, if I print from the scanner the print is ok, but if I “save as” then print it its no good,  in trying to find out the problem I found that the size of the file was 33.9 kb but the ones that I have done before (some time ago) where like 600kb, and printed out fine.
Can any one tell how to sort this out please  

[2k dummy]

Check your scanner settings. Scan rate (dpi) is much to low for photographs.

[ned1]

Hi, Thanks for that, But as I say if I print from the sanner its ok, its if i put it in my photos and print from there   the file size comes out at about 33kb in j-peg :-/  
ned1
ps in the past the file size would come out at about 600KB in j-peg

[2k dummy]

When you print directly from the scanner, you are in copy mode, not scan mode. There is a very big difference. Check your scan mode settings.

[ned1]

Hi, I  Checked the scan settings, which is 150dpi,
which is default for photos on the scanner !!
ned1